Cylinder set DMP 70cc (45mm) Reed valve Inlet + Butterfly Exhaust Port! - 21mm Dellorto Replica Carburetor Puch Maxi

Cylinder set DMP 70cc (45mm) Reed valve Inlet + Butterfly Exhaust Port! - 21mm Dellorto Replica Carburetor Puch Maxi

• DMP cylinder set 70cc (45mm)
• With butterfly valve exhaust port!
• Cylinder with a lot of tuning potential!
• Set with a 21mm Dellorto Replica carburetor.

Data:

• Cylinder capacity: 70cc.
• Bore: 45mm.
• Piston pin: 12mm.
• Aluminium, Nicasil wall.
• DMP.

​Complete set with:

• 1x Cylinder 70cc DMP (45mm)
• 1x Piston with piston rings.
• 1x Piston pin with clips.
• 1x Cylinderhead 50cc OM.
• 1x Feet gasket.
• 1x Head gasket.
• 2x Reed valve gasket.
• 1x Exhaust gasket.

• 1x Reed valve 2-Valves DMP.
• 1x Manifold 21mm (Sideways)
• 1x Carburetor 21mm Dellorto PHBG Replica.
• 1x Jet set 5mm Dellorto (Sizes 88-94)
• 1x Air filter Twin Air.
• 1x Spark plug NGK BH7S.

Pay attention!

• Piston has a 38mm dome, so the best is to use a 38mm cylinder head.
• For the best result cut a hole in the piston or shorten the inlet side of the piston.
• Its beter to replace the steel reed valve plates with Carbon / Carbonit (The steel reed valve plates can break)

Suitable for:

• Puch Maxi Models.